Many customers install miniature planetary geared motors and run them for a long time, and the temperature of the reducer will be very high. 1. Miniature geared motors are also called planetary geared motors, which means that the load is often greater than the manufacturer’s regular rated load. This is because the load is too large, the gears in the reducer mesh tightly, and the friction increases, resulting in a relatively large load. 2. The internal structure of the reducer is not suitable for speed input. There are customer reactions.
The same motor is installed in the same reducer, but the reduction ratio of the reducer is different, but the noise and heat are different. But what is the reason for this?
After effective inspection and analysis, we found that the first-stage solar Air conditioning fan motor suppliers https://www.chinakxdq.com/product/air-conditioning-fan-motor/ teeth at the input end of the reducer with severe heat generation are larger. At this time, the sun teeth perform a deceleration motion and the planetary teeth perform an acceleration motion. Naturally, the heat is even greater. In order to solve this kind of problem, it is advisable to use other reduction ratio reducers or change the internal gear structure (the cost is greater). Of course, there are many manufacturers of miniature planetary geared motors, and their occupations are not very consistent, but the reasons for the overheating of the geared motors are mainly the above two points.
The same motor is installed in the same reducer, but the reduction ratio of the reducer is different, but the noise and heat are different. But what is the reason for this?
After effective inspection and analysis, we found that the first-stage solar Air conditioning fan motor suppliers https://www.chinakxdq.com/product/air-conditioning-fan-motor/ teeth at the input end of the reducer with severe heat generation are larger. At this time, the sun teeth perform a deceleration motion and the planetary teeth perform an acceleration motion. Naturally, the heat is even greater. In order to solve this kind of problem, it is advisable to use other reduction ratio reducers or change the internal gear structure (the cost is greater). Of course, there are many manufacturers of miniature planetary geared motors, and their occupations are not very consistent, but the reasons for the overheating of the geared motors are mainly the above two points.
コメント